Sponsored Ads
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   South East Mopars Forum > Mopar Models > Dodge Ram Forum > 2ND Gen : 1994 - 2002 > General Discussions
Become a Supporting Member         Become a Preferred Vendor

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 01-26-2011, 09:35 PM   #11
 
RamSport97's Avatar
RamSport97
V6 Member
 
Join Date: Aug 2010
Location: Crystal River, FL
Name: Patrick
Age: 36
Posts: 406
Send a message via AIM to RamSport97 Send a message via Yahoo to RamSport97
Default
I have my sensor in the servo port right where the dipstick tube meets the tranny. I read about 135 cruising, and around 155 towing my trailer full of lawn equipment.


__________________


Save the wave!

RamSport97 is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
AutoMeter Gauges F/S. Stealth Mode Misc. Stuff 9 12-27-2010 09:45 PM
Mechanical Trans Temp Gauge Install 004x41500 DIY Articles 0 10-18-2010 03:01 AM