Semopar Forum

**txbass06** · 09-13-2011, 01:32 PM

Looks like I'll be buying a new intake manifold for my truck. Put a new water pump on my truck about 7 months ago and broke a bolt off in the intake that holds the water outlet down. Got it out and put a heli-coil in and thought it was good. Started seeping water about 3 months ago. Put a new gasket on and thought it fixed it but it's back to leaking again.

So I'm just going to replace with a new one. I know there's not many options for intake manifolds for the magnum series, and I'm not paying $600+ for the Mopar, so I'll probably try to source one from a salvage yard around here.
Aside from the plenum issue, is there anything you guys can think of I need to look at/replace while I'm in there?

Sent from my iPhone 4 using Tapatalk

**SmokedRam** · 09-13-2011, 04:39 PM

You could mod the runners on it...thats about the only mod I know you can to the stock kegger....and you're right, there isnt many options for intakes...you can get that Air gap, but it is useless without other supporting engine mods...

**SmokedRam** · 09-13-2011, 04:42 PM

Here is a DIY on the kegger mod...

http://dodgeforum.com/forum/2nd-gen-...egger-mod.html

**txbass06** · 09-13-2011, 07:24 PM

That's more than likely what I'll end up going with. No since in spending all that money on an intake for a heavy ass 4x4. It's never gonna be fast lol. I'll snatch one out of a junk yard and have it ready to bolt on when I tackle it.
I'm planning on a header back exhaust with our tax return but no other go fast stuff but gears

Sent from my iPhone 4 using Tapatalk